Can You Use WD-40 On Sewing Machines?

|

Yes you can use WD-40 on sewing machines. It is a lubricant and will help to keep the machine running smoothly.

However it is not a substitute for sewing machine oil which should be used to lubricate the moving parts of the machine.

WD-40 is also a good cleaner.

If your machine becomes gummed up with thread or lint you can spray it with WD-40 and wipe it clean.

Be sure to wipe off any excess WD-40 before using the machine as it can cause fabrics to become greasy.

Should I Use WD-40 On My Sewing Machine?

WD-40 is not a sewing machine lubricant. It is a water displacement product that can be used to clean and protect metal parts.

If you’re looking for a sewing machine lubricant try sewing machine oil or a silicone-based lubricant.

Silicone lubricants are non-staining and have a low evaporation rate making them ideal for use on sensitive surfaces.

What Is A Good Substitute For Sewing Machine Oil?

There are a few different options you can use as a substitute for sewing machine oil.

One is to use mineral oil which can be found at most pharmacies or drugstores.

Another option is to use WD-40 which is a lubricant that can be found at most hardware stores.

Finally you can also use olive oil which is a food-grade oil that can be found at most grocery stores.

Whichever oil you choose just make sure to apply it sparingly to avoid over-lubricating your sewing machine.

How Do I Lubricate My Sewing Machine?

There are a few different ways to lubricate a sewing machine. One way is to use a commercial sewing machine lubricant.

Another way is to use mineral oil or silicone oil.

And finally you can use a light machine oil such as 3-in-1 oil.

To apply the lubricant remove the needle and bobbin from the machine and place the lubricant in the shuttle race (or where the needle goes).

Put the needle and bobbin back in place turn on the machine and let it run for a minute or two.

Then turn off the machine and wipe off any excess lubricant.

Is WD-40 Good For Machinery?

WD-40 is meant to protect metal parts from corrosion and it does a good job at that. It also displaces moisture which can cause electrical shorts.

But it’s not a lubricant so it’s not ideal for machinery that needs to move smoothly.